[FS#3323] Buffalo WZR-600DHP needs kmod-usb-ohci for USB to work

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - Boris Gjenero (dreamlayers) 

Attached to Project - OpenWrt/LEDE Project
Summary - Buffalo WZR-600DHP needs kmod-usb-ohci for USB to work
Task Type - Bug Report
Category - Kernel
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Low
Priority - Very Low
Reported Version - openwrt-19.07
Due in Version - Undecided
Due Date - Undecided
Details - In both openwrt-15.05.1-ar71xx-generic-wzr-600dhp-squashfs-tftp.bin and openwrt-19.07.3-ar71xx-generic-wzr-600dhp-squashfs-sysupgrade.bin USB did not work. Power was available at the USB port, but plugging in various USB devices did absolutely nothing. I had to install kmod-usb-ohci to make USB start working.

I feel this is a bug because in 19.07.3 kmod-usb-ehci is already installed. So, one might think that required USB modules are there and something is wrong.

I tried both USB 1.1 and 2.0 high speed devices before. The ohci module is required even to use USB 2.0 high speed devices.

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3323

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.