[FS#3471] Mikrotik RB911-5Hn propper nand detection failed
OpenWrt Bugs
openwrt-bugs at lists.openwrt.org
Sun Nov 29 11:31:20 EST 2020
THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.
The following task has a new comment added:
FS#3471 - Mikrotik RB911-5Hn propper nand detection failed
User who did this - Alexandros C. Couloumbis (acoul)
----------
Hello rogerpueyo,
//Could you please give the sysupgrade image a try and tell me if it works? Or you can compile it from my branch (linked above). Then the patch will be ready. //
sysupgrade works just fine
root at OpenWrt:~# df
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/root 2816 2816 0 100% /rom
tmpfs 29080 56 29024 0% /tmp
/dev/ubi0_2 107840 44 102956 0% /overlay
overlayfs:/overlay 107840 44 102956 0% /
tmpfs 512 0 512 0% /dev
//Can I add "Tested-by: Alexandros C. Couloumbis your at email.ext" to the commit? //
yes you can
//Sorry, this is difficult to understand! ;)//
you are right. let me try again.
tftp booting [[https://downloads.openwrt.org/releases/18.06.9/targets/ar71xx/mikrotik/openwrt-18.06.9-ar71xx-mikrotik-vmlinux-initramfs-lzma.elf|18.06.9 image]] on my rb911-nand board, provides /sys/firmware/routerboot/ext_wlan_data, loads ath9k & wlan0 is visible & operational
tftp booting [[https://downloads.openwrt.org/releases/19.07.4/targets/ar71xx/mikrotik/openwrt-19.07.4-ar71xx-mikrotik-vmlinux-initramfs-lzma.elf|19.07.4 image]] gets into FAILSAFE MODE, /sys/firmware/mikrotik is empty & ath9k loads but wlan0 is not visible or operational & no ath/ath9k dmesg is reported
tftp booting the 19-snapshot image you sent me, /sys/firmware/mikrotik is empty while ath9k loads & wlan0 is visible & operational
my question is how come, the older 18.x trunk offers the wifi calibration data while the newer 19.x does not
also, would it be possible to sent me your 19.x image with the kernel option "CONFIG_IKCONFIG_PROC=y"
cheers
----------
More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3471#comment9070
You are receiving this message because you have requested it from the Flyspray bugtracking system. If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.
More information about the openwrt-bugs
mailing list