[PATCH 4/4] arm64: dts: imx8mp-evk: enable HDMI

[Luca Ceresoli]

Hello Lucas,

On Thu, 2 Mar 2023 16:35:25 +0100
Luca Ceresoli <luca.ceresoli at bootlin.com> wrote:

> Hello Lucas,
> 
> On Fri, 26 Aug 2022 21:29:32 +0200
> Lucas Stach <l.stach at pengutronix.de> wrote:
> 
> > Enable the DT nodes for HDMI TX and PHY and add the pinctrl for the few
> > involved pins that are configurable.
> > 
> > Signed-off-by: Lucas Stach <l.stach at pengutronix.de>  

Any updates to these patches? I haven't found any v2 on the list.

> I'm joining late to this party... Is this the latest version of this
> series? I haven't found any more recent, but if it is not the case
> would you point me to the most recent one please?
> 
> > +	pinctrl_hdmi: hdmigrp {
> > +		fsl,pins = <
> > +			MX8MP_IOMUXC_HDMI_DDC_SCL__HDMIMIX_HDMI_SCL	0x1c3
> > +			MX8MP_IOMUXC_HDMI_DDC_SDA__HDMIMIX_HDMI_SDA	0x1c3  
> 
> Is the low nibble (0x3) right?BIT(0) is reserved according too the
> reference manual.
> 
> Also, all the non-reserved bits in that nibble are bits 1 and 2, which
> set the drive strength. For an I2C line it seems that the minimum drive
> strength (0x0) should be enough for an I2C line: with any drive
> strength setting the supported frequency is >= 65 MHz.
> 
> > +			MX8MP_IOMUXC_HDMI_HPD__HDMIMIX_HDMI_HPD		0x19
> > +			MX8MP_IOMUXC_HDMI_CEC__HDMIMIX_HDMI_CEC		0x19  
> 
> Here as well, bits 0 and 3 are reserved.

About these pinctrls, I am using these settings on the MSC SM2-MB-EP1
board and they appear to be working just as those you are using (but I
haven't tested CEC):

  MX8MP_IOMUXC_HDMI_DDC_SCL__HDMIMIX_HDMI_SCL     0x1c2
  MX8MP_IOMUXC_HDMI_DDC_SDA__HDMIMIX_HDMI_SDA     0x1c2
  MX8MP_IOMUXC_HDMI_CEC__HDMIMIX_HDMI_CEC         0x10
  MX8MP_IOMUXC_HDMI_HPD__HDMIMIX_HDMI_HPD         0x10

Best regards,
Luca

-- 
Luca Ceresoli, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com