[RFC PATCH] ARM: dts: stm32: remove typec port dtbs_check warning on stm32mp15xx-dkx

[Alexandre TORGUE]

On 4/12/23 17:13, Fabrice Gasnier wrote:
> According to usb-connector.yaml, typec connector should always use:
> - ports property
> - with port at 0 (required).
> This is also true for a single HS port. This removes dtbs_check warning:
> stusb1600 at 28: connector: Unevaluated properties are not allowed ('port'
> was unexpected)
> 
> Downside is it introduces another warning when building with W=1:
> 
> Warning (graph_child_address): /soc/i2c at 5c002000/stusb1600 at 28/connector/
> ports: graph node has single child node 'port at 0', #address-cells
> /#size-cells are not necessary
> 
> By removing #address-cells/#size-cells as suggested, another couple of
> W=1 warning shows up:
> Warning (avoid_default_addr_size): /soc/i2c at 5c002000/stusb1600 at 28/
> connector/ports/port at 0: Relying on default #address-cells value
> Warning (avoid_default_addr_size): /soc/i2c at 5c002000/stusb1600 at 28/
> connector/ports/port at 0: Relying on default #size-cells value
> 
> Is there a clean way or necessary change to reach a clean build and clean
> dtbs_check ?
> Maybe this kind of concern has already been addressed ?
> As far as I understand, the OF graph allows a single port {} node (e.g.
> code being reworked here). Could this be added in relevant dtschema, to
> address the single HS port use case (usb-connector.yaml) ?
> 

Rob, Krzysztof, do you an idea to figure out this issue ?

Thanks in advance
Alex


> Signed-off-by: Fabrice Gasnier <fabrice.gasnier at foss.st.com>
> ---
>   arch/arm/boot/dts/stm32mp15xx-dkx.dtsi | 11 ++++++++---
>   1 file changed, 8 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/stm32mp15xx-dkx.dtsi b/arch/arm/boot/dts/stm32mp15xx-dkx.dtsi
> index cefeeb00fc22..41e79c8cc752 100644
> --- a/arch/arm/boot/dts/stm32mp15xx-dkx.dtsi
> +++ b/arch/arm/boot/dts/stm32mp15xx-dkx.dtsi
> @@ -259,9 +259,14 @@ connector {
>   			power-role = "dual";
>   			typec-power-opmode = "default";
>   
> -			port {
> -				con_usbotg_hs_ep: endpoint {
> -					remote-endpoint = <&usbotg_hs_ep>;
> +			ports {
> +				#address-cells = <1>;
> +				#size-cells = <0>;
> +				port at 0 {
> +					reg = <0>;
> +					con_usbotg_hs_ep: endpoint {
> +						remote-endpoint = <&usbotg_hs_ep>;
> +					};
>   				};
>   			};
>   		};